Call now to get tree service including tree clear, tree drop, bush delimbing, shrub chop, stump chopping and bunch more within USA:


Click to call

Call us now +1 (855) 280-15-30










Now that the seals are all done, the rest is pretty straight forward.

Fork Seals & Bushings. K-Tech front fork oil and dust seals are manufactured by NOK and are a direct replacement for the original equipment parts. NOK are chosen as original equipment by all Japanese suspension manufacturers for their quality and durability. K-Tech front fork slide and glide bushes are a direct replacement and manufactured to. Dec 27, Take the front wheel and fender off the bike.

Loosen the upper pinch bolts that are holding the very top of the fork legs by the caps. Use a 24mm wrench and loosen the fork caps. Just break them loose, don’t take the caps off at this point. If you take the forks off the bike before you loosen the caps, you’ll have a bitch of a time holding Estimated Reading Time: 11 mins.

Once you get the fork tubes separated, remove all of the loose bushings, washer, and seal from the tubes and clean everything out thoroughly.

HIGH SMOOTHNESS FORK BUSHING Technical Details: Load capacity: N/mm2 Coef(u) Friction: Temperature: + °C. Aug 26, The outer bushing gets up over the inner bushing and tears the teflon. Just score yourself some new bushings and all will be good. Just make sure you're using good seals too though or you'll get a lot of stiction there as well with certain seals and wipers. The bushings in the all balls type kits are actually pretty good IMO.

Just steer clear. Hello everyone, I wanted to rebuild my front forks. I bought the seals, dust caps, and new clips (circ-rings?). Also bought the oil. All was going well until I done fuck it up. I pressed down the bushing that goes on the outside fork (not the"stanchion".

Aug 09, 6, Location. Mc Carty Rd. Deerfield, Michigan Aug 9, #1. As luck would have it, I have a weeping fork seal on the right side. I firse noticed the brake disc getting oily and looked closer. Had a bit of oil laying on the caliper mounting boss and the telltale oil/crud on the slider.

Time for seals. KFGB46T.Add to Cart. 48mm WP Guide Bushing IDmm ODmm HT Learn More. WFGBAdd to Cart. 43mm WP Fork Guide Bushing ID. Pivot WorksSwing Arm / Shock / Linkage Bearing Combo.- Sale. Up to 10%. out of 5 stars. (49) reviews. These bumpers are at a 90° angle to protect corners on equipment, walls, and docks from damage caused by carts, vehicles, and other moving objects.

All have a hard rating to withstand high levels of impact. They are nonmarring and can be used outdoors. Unthreaded-hole bumpers mount with screws. Polyurethane foam bumpers resist abrasion better than plastic or vinyl.